Enterasys-networks Enterasys SecureStack B2 B2G124-24 Bedienungsanleitung PDF herunterladen (Seite 36)

Installing the Switch on a Flat Surface

3-6 Hardware Installation

3. LocatethereleasetabunderthefrontendoftheMini‐GBIC.Forthetypeof

Mini‐GBICshowninFigure 3‐1,pushinonthereleasetabasfarasitwillgotorelease

theMini‐GBICfromtheportslot.ForthetypeofMini‐GBICshown

inFigure 3‐2,pull

outonthereleasetabtoreleasetheMini‐GBICfromtheportslot.

4. GraspthesidesoftheMini‐GBICandpullitstraightoutoftheportslot.

IfstoringorshippingaMini‐GBIC,whichhasafiber‐opticconnector,insertitsprotective

dust

covertoprotecttheendsofthefiber‐opticfibersfromdustorcontamination.

Installing the Switch on a Flat Surface

Wheninstallingtheswitchonaflatsurface,theinstallationoftherubber feetis

recommendedtopreventtheswitchfromslidingonaflatsurface.Installingtherubber

feetisoptionalifyouareinstallingtheswitchinarack.Toinstalltherubberfeet,proceed

to“Installingthe

RubberFeet”instructionsbelow.Forinstructionstorackmountthe

switch,proceedto“RackMountingtheSwitch”onpage 3‐9.

Installing the Rubber Feet

Toinstalltherubberfeet,refertoFigure 3‐3andproceedasfollows:

1. Placetheswi tchonitsbackonasturdyflatsurfacetogainaccesstothebottomofthe

chassis.

2. Removethe fourrubberfeetfromtheirplasticbagintheshipping box.

3. Locatethefourmarkedlocationson

thebottomfourcornersofthechassis.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 79 80

Keine Kommentare

Enterasys-networks Enterasys SecureStack B2 B2G124-24 Bedienungsanleitung Seite 36