
5-9
Configuring APs in a Point-to-Point Network
Wireless Parameters Used in a Point-to-Point Network
The following AP parameters are not used in this configuration:
The following describes the settings used in a point-to-point network:
• Slot 1/Slot 2: (RoamAbout R2 only): Select the slot to be configured.
• Channel: Both APs must use the same channel.
• Station name: Select a unique name that helps identify the location of the AP. Each
AP should have a unique station name.
• Bridge Mode: Set to LAN-to-LAN Endpoint.
• Remote Wireless MAC Address: Enter the wireless MAC address of the remote AP.
• Transmit Rate: A fixed rate is recommended for most environments. See “Transmit
Rate” on page 2-5.
• RTS Threshold: The default setting works well in most environments. See
“RTS/CTS Protocol” on page 2-9.
• Spanning Tree: Set to Enabled or Disabled. For more information, see “Spanning
Tree Protocol” on page 2-22.
• Wireless Network Name
• Secure Access
• IntraBSS Relay
• AP Density
• Power Management (DTIM Period)
• Multicast Transmit Rate
Kommentare zu diesen Handbüchern