Enterasys-networks DFE-256MB-UGK Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Hardware Enterasys-networks DFE-256MB-UGK herunter. Enterasys Networks DFE-256MB-UGK User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 5
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
PN 9033946 Page 1 of 5
DFE Series Module
Memory Upgrade Kit (DFE-256MB-UGK)
Installation Instructions
Before You Begin
These installation instructions describe how to upgrade the Dual-Inline Memory Module (DIMM)
on a DFE series module from 128 MB to 256 MB using the 256 MB SDRAM DIMM included in this
DFE-256MB-UGK
kit.
To help eliminate any potential problems during or after installation, read and understand all of
the instructions in this document and in the release notes supplied with the DFE-256MB-UGK
upgrade kit.
If there are missing or damaged parts, or you need help installing the DIMM, contact Enterasys
Networks for assistance. (Refer to “Getting Help” at the end of this document.)
Kit Parts
Required Tools
Caution: Only authorized personnel should install the DFE Series Module Memory Upgrade Kit
(DFE-256MB-UGK).
Note: Access to advanced routing features, such as Protocol Independent Multicasting
(PIM) and Load Share Network Address Translation (LSNAT) currently require memory
greater than 128 MB. Please consult the Release Notes to see which additional features
require this memory upgrade.
Qty Item
1 256 MB SDRAM DIMM assembly
1 URL Location Card
1 This document (PN 9033946)
Qty Item
1 Antistatic wrist strap (not supplied)
Seitenansicht 0
1 2 3 4 5

Inhaltsverzeichnis

Seite 1 - Installation Instructions

PN 9033946 Page 1 of 5DFE Series ModuleMemory Upgrade Kit (DFE-256MB-UGK)Installation InstructionsBefore You BeginThese installation instructions desc

Seite 2 - Preparation

PreparationPage 2 of 5 PN 9033946PreparationThe DIMM is located on the main pc board assembly of the DFE Series Module. In some cases, depending on th

Seite 3 - DIMM Replacement Procedure

DIMM Replacement ProcedurePN 9033946 Page 3 of 5DIMM Replacement ProcedureAlthough the following replacement procedure describes how to replace a DIMM

Seite 4 - Completing the Installation

Completing the InstallationPage 4 of 5 PN 90339463. Push the DIMM ➁ further into the connector until the two DIMM alignment notches ➄ and the tabs on

Seite 5 - Getting Help

Getting HelpPN 9033946 Page 5 of 5Getting HelpFor additional support related to the module or this document, contact Enterasys Networks using one of t

Kommentare zu diesen Handbüchern

Keine Kommentare