Enterasys-networks ROAMABOUT RBT-1602 Bedienungsanleitung PDF herunterladen (Seite 68)

Connecting the Antenna Cables

3-36 Antenna Installation

Antenna Cable Route

Thecableshouldnotbeinstalledintotightpositions,asbendingorapplyingexcessiveforcetothe

connectorsmaydamagetheantennacable.Alwaysallowthecabletobendnaturallyaround

corners.

Thelow‐lossantennacablemustbesecuredalongitscompletelength.Nopartofthecableshould

allowedtohangfree.Thisisparticularlyimportantforcablepartsthatareinstalledoutdoors.

Theantennacablesandcableconnectorsarenotdesignedtowit hstandexcessiveforce:

•Donotuseconnectorsascablegripstopullcablethroughracewaysorconduits.

•Donotusecableconnectorstosupporttheweight

ofthecableduringorafterinstallation.

•Donotusetoolstotightenconnectors(finger‐tightenonly).

Connecting the Cables

Oncetheantennaisproperlyinstalled,youcanconnecttheantennatotheRoamAboutAPviathe

RoamAboutLightningProtector.

1. Verifythatthelow‐lossantennacableisproperlyconnectedtotheantennacable.

2. Securethelow‐losscabletothemastsuchthatthecableconnectorsdonotsupportthefull



weightofthecable.

3. Provideadrip‐loopatthebottomofthelow‐losscablejustbeforeitentersthebuilding.

4. Connecttheoppositeendofthelow‐losscabletotheRoamAboutLightningProtector.

5. Priortosecuringthecablealongitscompletelength,referto“OptimizingRoamAbout

OutdoorPoint‐

to‐PointAntennaPlacement”onpage 3‐37.Ifrequired,adjustthedirectionof

theantenna.

6. Oncetheinstallationhasbeenfullytested,tightenantennamountingnutstolocktheantenna

intoitsposition.

7. Securethecablealongitscompletelength.Nopartofthecableshouldbeallowedtohangfree.

8. Use

waterproofstretchtapetosealalloutdoorconnectors.

Caution: To avoid damage to the antenna cable and connectors, do not use tools to tighten cable

connectors.

Precaución: para evitar daños en los cables y el conector de la antena, no use herramientas para

apretar los conectores.

Achtung: Verwenden Sie kein Werkzeug zum Anziehen der Kabelanschlüsse. Durch Werkzeug

können das Kabel und die Anschlüsse beschädigt werden.

Caution: To prevent damage, avoid over-tightening the connectors, nuts, and screws used to

mount the antenna.

Precaución: evite apretar demasiado los conectores, tuercas y tornillos usados para instalar la

antena, para no dañarlos.

Achtung: Beugen Sie Schaden vor, indem Sie die Anschlüsse, Muttern und Schrauben für die

Antenne nicht zu fest anziehen.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 91 92

Kommentare zu diesen Handbüchern

Keine Kommentare

Enterasys-networks ROAMABOUT RBT-1602 Bedienungsanleitung Seite 68

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Enterasys-networks ROAMABOUT RBT-1602