Enterasys Networks G3G124-24 Bedienungsanleitung PDF herunterladen (Seite 26)

Mounting the Switch

2-4 Installation

Placing the Switch on a Flat Surface

Wheninstallingtheswitchonaflatsurface,theinstallationoftherubber feetisrecommendedto

preventtheswitchfromsliding.Also,thesurfacemustbeabletosupport15.5kg(35lbs)ofstatic

weight.

Toinstalltherubberfeet,proceedasfollows:

1. Placetheswitchupsidedownon

asturdyflatsurface.

2. Removethefourrubberfeetfromtheshippingbox.

3. Removetheprotectivestripfromthebackofonerubberfootandpositionitononeofthe

cornersonthebottomoftheswitch.Pressfirmlyintoplace.Repeatthisproceduretoinstall

theremainingrubberfeetin

theothercorners.

4. Afterinstallingtherubberfeet,returntheswitchtoitsuprightposition.

5. Placetheswitchinitsfinallocation.

Installing the Switch into a Rack

TheG‐SeriesEthernetswitchcanbemountedinastandardEIA‐310‐Dcompliant48.26‐centimeter

(19‐inch)equipmentrack.Tomounttheswitchintoarack,youmustfirstinstalltherack‐mount

kit,whichconsistsoftwobrackets.Youmustprovidethemountinghardwaretoattachtheswitch



bracketstotherails.

Toinstalltherack‐mountkitandtheninstalltheswitchintotherack:

1. Placetheswitchonasturdyflatsurface.

2. Installoneofthebracketsprovidedintherack‐mountkittothesideoftheswitchusingthe

screwsprovidedasshowninFigure 2‐

3. Repeatthepreviousstepstoinstalltheotherbrackettotheotherside.

Caution: Before installing the screws as described in this installation procedure, refer to “Torque

Values” on page A-5.

Precaución: Antes de retirar los tornillos, tal como se describe en las instrucciones de instalación,

consulte “Torque Values” on page A-5.

Note: The G-Series Ethernet switch (with rubber feet installed) will exceed the 2U high Richmond

standard and will not comply with the requirements for mounting in a 19-inch (48.26-centimeter)

rack. Remove the rubber feet, if installed, before installing the switch into a rack.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 58 59

Keine Kommentare

Enterasys Networks G3G124-24 Bedienungsanleitung Seite 26