Enterasys Networks G3G124-24 Bedienungsanleitung PDF herunterladen (Seite 42)

Completing the Installation

2-20 Installation

2. InsertthecableconnectorintotheSFP/XFPconnectoruntilitclicksintoplace.

Figure 2-11 Cable Connection (LC shown) to Uplink Port with SFP/XFP Installed

3. Plugtheotherendofthecableintotheappropriateportontheotherdevice.Somecablesmay

beterminatedattheotherendwithtwoseparateconnectors,oneforeachfiber‐opticstrand.

Inthiscase,ensurethatthetransmitfiber‐opticstrandfrom

theG‐Seriesisconnectedtothe

receiveportoftheotherdevice,andthereceivefiber‐opticstrandontheG‐Seriesisconnected

tothetransmitportoftheotherdevice.

4. RepeatthisprocedureforotherSFP/XFPports,ifneeded.

5. IfanSFP/XFPportisunused,installadust

cover.

Completing the Installation

1. Powerontheswitch.

2. VerifythatthePWR1andPWR2powerLEDsarelit.Referto“PowerLEDDisplays”on

page 2‐12forinformationoninterpretingthepowerLEDs.

3. VerifythattheSYSTEMLEDblinksinitiallythenbecomessolidgreen.

4. Makesurethatthenetworkdevicesconnectedtotheswitchports

arepoweredon,thenverify

thateachLink/Activ ityLEDisON(solidgreenorblinkinggreen).

5. Atthedeviceconnectedtotheconsoleport,performthefollowing:

a. EnteradminforUsername.

b. AtthePasswordprompt,pressENTER(RETURN).

Note: Leave the protective covers in place when the connectors are not in use to prevent

contamination.

1 Combo SFP port with MGBIC installed 2 LC cable connector 3 Release tab

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 58 59

Keine Kommentare

Enterasys Networks G3G124-24 Bedienungsanleitung Seite 42