Enterasys Networks CSX7000 Bedienungsanleitung PDF herunterladen (Seite 514)

100

101

USER’S GUIDE

514 CyberSWITCH

[IPX SAP] Buffers allocated

The IPX SAP successfully allocated the buffers needed to transmit IPX SAP packets.

[IPX SAP] SAP Protocol Initialization successful

The IPX SAP protocol was successfully initialized.

[IPX SAP] Shutdown complete

The IPX SAP protocol was successfully shutdown via Dynamic Management. No IPX SAP service

information will be transmitted or received. Any services learned via IPX SAP will soon expire.

[IPX SAP] Space available in service table

A service entry has become available in the full service table.

[IPX SAP] Unable to add service, service table full

The service table has become full. The maximum number of service entries should be increased.

Note: This message will not recur in the log until space becomes available in the service table.

[IPXCP] Add Network Address to Pool with value above <network address>

This message informs the administrator that negotiation was not possible since non-convergence

was detected the network address sent by the peer was not acceptable by us and we do not have

any network address to assign to the peer. The possible remedy is to configure more IPX addresses

with a value more than <Network Address> in the Address Pool.

[IPXCP] IPX Address Match.

[IPXCP] Device <device> address same as another device address

The remote device indicated by <device> requested to use an already existing IPX network number

and node number.

[IPXCP] Our Node Address is <node address>

This message informs the administrator that the peer has assigned us a node number because the

system did not have a node address and the peer needs a node address. This node address will be

used by the peer to identify this system.

[IPXWAN] Master Slave Conflict. Change Internal Network Number above <present value>

This message indicates that over the IPXWAN link, the master and slave roles could not be

determined. The internal network number of the system must be changed to ensure proper

IPXWAN negotiation to occur.

[IPXWAN] IPX Internal Network Number must be configured.

You must configure a valid internal network number in order for IPX routing to work properly.

L3_CallRefSelect Call Reference wrapped

Status message indicating that Layer 3’s call reference value has wrapped. If this message is posted

frequently, report the problem.

LAN Adapter Abort

The Ethernet adapter or subsystem is being interrupted as part of the error recovery process. If the

system fails to operate normally, or the warning continues to occur, then report the event using the

problem reporting form included in Getting Assistance.

1 2 ... 509 510 511 512 513 514 515 516 517 518 519 ... 728 729

Kommentare zu diesen Handbüchern

Keine Kommentare

Enterasys Networks CSX7000 Bedienungsanleitung Seite 514

Kommentare zu diesen Handbüchern