Enterasys Networks CSX7000 Bedienungsanleitung PDF herunterladen (Seite 215)

100

101

Central Site Remote Access Switch 215

ONFIGURING

NODE

ERVER

NFORMATION

RADIUS RFC2138

VERIFICATION AND DIAGNOSIS

After configuring the RADIUS Accounting Server, connect via a dial-in client, and then disconnect.

On the RADIUS Accounting Server, verify that it has received the Accounting Start and Stop

message. If it has not, check the CyberSWITCH system log. If there is a message that no response

was received from the Accounting Server, then verify your configuration.

To verify configuration, use CFGEDIT and check:

• is RADIUS Accounting enabled (Security, Off-node Server Information, Misc options)?

•correct IP address (Security, Off-node Server Information, RADIUS Acctng)?

• correct shared secret?

• correct UDP port number?

To determine if you have communications with the RADIUS Accounting Server, issue the

IP ping

x.x.x.x

command, where

x.x.x.x

is the RADIUS Accounting Server’s address.

If this test fails on occasion, yet is successful at other times, it may be that the connection between

the CyberSWITCH and the RADIUS Accounting Server is inadequate to provide reasonable

accounting information.

RADIUS RFC2138

In addition to the Cabletron implementation of RADIUS (which supports dialout), the

CyberSWITCH also supports an RFC2138-compliant implementation. If you are using an RFC2138

RADIUS, be sure to enable this RFC2138 implementation.

ENABLING RADIUS TYPE

USING CFGEDIT

1. From CFGEDIT Main Menu, select (3) Security.

2. Select (5) Off-node Server Information.

3. Select Misc Off-node Server Options. A screen similar to the following will display current

settings:

4. Check the current setting for Radius type.

Note: This selection toggles back and forth. If the current setting is RFC2138 compliant, you

will enable the Cabletron implementation by selecting Radius Type. If you select Radius

Type again, you will return the function to RFC2138 compliance.

5. Press <RET> to return to the previous menu.

Misc Off-node Server Options Menu:

Current Settings

1) Radius Accounting (Enable/Disable) Enabled

2) Radius Type (RFC2138/Cabletron) RFC2138 compliant

3) Dynamic Device Option (Enable/Disable) Enabled

4) Dynamic Device Default Settings

Select function from above or <RET> for previous menu:

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 728 729

Kommentare zu diesen Handbüchern

Keine Kommentare

Enterasys Networks CSX7000 Bedienungsanleitung Seite 215

Kommentare zu diesen Handbüchern