Enterasys Networks CSX7000 Bedienungsanleitung PDF herunterladen (Seite 218)

100

101

USER’S GUIDE

218 CyberSWITCH

If a specific set of parameters is required for a particular device, configure the specific device

independently, either locally (through the on-node device list) or in CSM. The CyberSWITCH will

look at the configured device table first before proceeding to the dynamic device default

configuration. Since the configured device table overrides the default configuration, leave the

dynamic device option enabled, and configure specific devices for exceptional cases only.

TACACS AUTHENTICATION SERVER

CONFIGURING A TACACS AUTHENTICATION SERVER

Note: In order for the CyberSWITCH to reference the TACACS server, basic IP information must

be configured. If the IP Host mode is not in use, you must also configure the following:

• a LAN Network interface must be configured appropriately for the IP network

connected to each LAN port on the system

• at least one WAN Network Interface must be configured for TACACS to be operable

SING CFGEDIT

1. Select option (3), TACACS from the Off-node Server Information menu. If you need guidance

to find this menu, refer to the instructions provided in the CSM Authentication Server

configuration section. The following screen will be displayed:

2. Select (1) Primary Server to enter the following information:

a. IP address of the Authentication Server

b. UDP port number used by the Authentication Server

3. Optional: configure a secondary TACACS Server with selection (2). In the event that the

primary server does not respond to system requests, the secondary server will be queried for

device authentication information. The address of the Secondary Server must not be the same

as the Primary Server.

4. Select (3) Access Request Retry to finish configuration. Specify the number of access request

retries that the system will send to the Authentication Server, as well as the time between

retries. You may also specify order of the TACACS authentication prompts for access request.

TACACS Authentication Server Menu:

Primary Server

IP Address is 001.002.003.004

UDP Port Number is 49

Secondary Server

IP Address is 001.002.003.008

UDP Port Number is 49

Access Request Retry

Number of Access Retries is 3

Time between Retries is 1 second

TACACS Packet Format is (ID CODE,PIN)

TACACS Server Configuration Options:

1) Primary Server

2) Secondary Server

3) Access Request Retry

Select function from above or <RET> for previous menu:

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 728 729

Kommentare zu diesen Handbüchern

Keine Kommentare

Enterasys Networks CSX7000 Bedienungsanleitung Seite 218

Kommentare zu diesen Handbüchern