Enterasys Networks CSX7000 Bedienungsanleitung PDF herunterladen (Seite 190)

100

101

USER’S GUIDE

190 CyberSWITCH

b. Press 2 at the above menu to enter the device’s AppleTalk address. If the device is over an

unnumbered link, enter 0.0. If the device is over a MAC dial-in port, you may either enter

an address, or leave the value at “none”.

c. Press 3 at the above menu, then follow the on-screen instructions to configure whether or

not dial out to this device is allowed for this device.

d. Press 4 at the above menu to specify an AppleTalk routing protocol the system should use

with this device. The options are None or RTMP. Currently RTMP is only supported for

devices who will be dialing into the CyberSWITCH via a MAC dial-in port.

Note: If you are configuring a device for AppleTalk Remote LAN, leave the above AppleTalk

information at the default values (DISABLED, None, DISABLED, None).

Refer to AppleTalk Configuration Elements for more information.

13. To enter any needed bridge information for this device, select Bridge from the Device Table

Menu. The following screen will be displayed:

You may enable or disable bridging for this device. If this device is to use a Remote LAN

interface or Remote LAN port, enable bridging. If you want dial out capabilities to this device,

enable Make calls for Bridge data.

For IP Remote LAN networks, you must explicitly configure the IP (Sub)Network number.

For IPX Remote LAN networks, you may configure the IPX external network number, or you

may leave the value at NONE. The IPX Spoofing Options for IPX Remote LAN devices are not

available at this time. For additional information, please refer to the Configuring IPX chapter,

Remote LAN Devices.

For AppleTalk Remote LAN networks, you may configure the AppleTalk network number/

range (used on the Remote LAN for this device), or you may leave the value at NONE.

14. To enable per-device compression information, select Compression from the Device Table

Menu. The following menu will then be displayed:

a. If compression is not already enabled for this device, press 1 and follow the onscreen

instructions to change the configuration to enabled.

b. If the remote device does not use 1 as the starting PPP STAC-LZS sequence number, press

2 to enter a new value for the starting sequence number.

Device Bridging: (device = "DAN")

1) IP (Sub)Network number NONE

2) Bridging ENABLED

3) Make Calls for Bridge data NONE

4) IPX Remote LAN Network Number NONE

5) IPX Spoofing Options

6) AppleTalk Network Number NONE

Select function from above or <RET> for previous menu:

Device Compression Menu: (device = "DAN")

1) Compression ENABLED

2) Starting PPP STAC-LZS Sequence Number 1

Select function from above or <RET> for previous menu:

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 728 729

Kommentare zu diesen Handbüchern

Keine Kommentare

Enterasys Networks CSX7000 Bedienungsanleitung Seite 190

Kommentare zu diesen Handbüchern