Enterasys Networks CSX7000 Bedienungsanleitung PDF herunterladen (Seite 495)

100

101

Central Site Remote Access Switch 495

YSTEM

ESSAGES

System Message Summary

Data link test successful: DSL <port #>, CES 1

This message applies for 1TR6 BRI only. If Layer 1 is established, a test will be done to determine if

the data link can be established. This message indicates successful test results.

Data link up: Slot=<slot #> Port=<port #> Ces=<communication endpoint suffix>

The data link on the specified line is active and can be used for establishing switched connections.

DCE Data Rate is invalid on FrStartPVC

The user has configured a data rate which is inconsistent with the application. This can only happen

with serial lines such as V.35 where the data rate must be specified in bits-per-second and the

configured rate is not valid.

Dedicated connection down: <slot #, port #>

The dedicated connection is down. Switched backup connections will be used, if available. This

message will occur if the other system is down, or if the network interface line is not connected, or

if the authentication of the remote device failed.

Dedicated connection to device <device name> up: <slot #>,<port #>

The indicated dedicated connection is operational.

[DHCP-P] Failed to close UDP port after terminating last DHCP client

An internal error occurred in the DHCP Proxy Client. When all DHCP client invocations are

terminated, the UDP ports used by the DHCP Proxy Client should be closed. Contact your

Distributor or Customer Support.

[DHCP-P] Failed to close UDP port (x), erc = <y>

This message appears when the DHCP Proxy Client is being disabled from Manage Mode and it

encounters an error while trying to close one or both of the UDP ports that it has open. Contact your

Distributor or Customer Support.

[DHCP-P] Failed to de-register with the IP Address Pool Manager, erc = <x>

This message indicates that a failure was encountered by the DHCP Proxy Client while it was being

disabled. It was unsuccessful in its attempt to de-register as a provider of “DHCP” addresses for

the IP Address Pool. Contact your Distributor or Customer Support.

[DHCP-P] Failed to open UDP port for first DHCP client

An internal error occurred in the DHCP Proxy Client. When the first DHCP client invocation starts,

the UDP ports used by the DHCP Proxy Client should open. Contact your Distributor or Customer

Support.

[DHCP-P] Failed to open UDP port (x), erc = <y>

This message appears when the DHCP Proxy Client is being enabled and it encounters an error

while trying to open one or both of the UDP ports that it requires for operation. Contact your

Distributor or Customer Support.

[DHCP-P] Failed to register with the IP Address Pool Manager, erc = <x>

This message indicates that a failure was encountered by the DHCP Proxy Client while it was being

enabled. It was unsuccessful in its attempt to register as a provider of “DHCP” addresses for the IP

Address Pool. Contact your Distributor or Customer Support.

1 2 ... 490 491 492 493 494 495 496 497 498 499 500 ... 728 729

Kommentare zu diesen Handbüchern

Keine Kommentare

Enterasys Networks CSX7000 Bedienungsanleitung Seite 495

Kommentare zu diesen Handbüchern